Hi, Ken!
The procedures at D. C. Cook each have a lookup table based on variable FW temperature and an assumed FW pressure of 930 psig (Unit 1) and 1000 psig (Unit 2).
We have an engineering evaluation addressing the insensitivity of enthalpy to varying FW pressure in the range 650 psig - 1010 psig (Unit 1) and 650 psig - 1050 psig (Unit 2). The assumed FW pressures are an approximate average of the nominal full power and 15% power FW pressures.
Differences are due to the two different secondary plants.
David Goff Reactor Engineer Donald C. Cook Nuclear Plant 269-465-5901 x1465
"Kenneth R Pike" kpike01@comcast.net Sent by: pwrrm@retaqs.com 10/15/2010 09:09 AM Please respond to Kenneth R Pike kpike01@comcast.net; Please respond to PWR Reactivity Management pwrrm@retaqs.com
To pwrrm@retaqs.com cc
Subject [Pwrrm] Manual calorimetric Feedwater Enthalpy determination
What method do you use to assign an Enthalpy to Feedwater, given FW Temperature and S/G pressure when using your backup Manual calculation?
Do you use compressed liquid steam tables at a single pressure and iterate on the temperature to assign a value, or iterate on both temp and pressure.
If you use a single value of pressure, is it nominal full power S/G press or something different?
Ken Pike (610) 277-8991 Ext.253_______________________________________________
---------------------------------------------------------------- This e-mail message and all attachments transmitted with it from the Nuclear Generation Group of American Electric Power are for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.