FCS Technical Specifications and Standard Technical Specifications state that the APD shall be enabled when RTP >= 15%. The APD trip is enabled by a bistable from the NIs, which may not be calibrated for several reasons (e.g., following downpower or after a refueling outage) and may be reading lower than actual power. Consequently, if NIs are reading low, the APD may not be enabled when actual RTP is above 15%. However, Technical Specifications also state that the NI calibration is not required for 12 hours after exceeding 20% RTP.

How do other plants handle this situation?

At FCS: 1) Our startup procedure has a step to adjust all NI and Delta-T power indications to the highest of all readings when the plant is at approximately 10% power. 2) Our bistable is set (reset) between 13.5 and 14.5% NI power. 3) Prior to exceeding 20% power by any indication, we verify that the APD and LOL trips are enabled.

My objective is to either remove or modify the procedure step for adjusting to the highest indication (item 1 above) when at 10% power for startups (power ascensions) during the cycle. This is desirable so that NIs don't have to be recalibrated when we return to power. The step was added about 12 years ago, and I'm not sure it was really necessary.

Barton P. Schawe, P.E. Principal Reactor Engineer Omaha Public Power District Tel: 402-533-7211 email: bschawe@oppd.commailto:bschawe@oppd.com

This transmission contains information which may be confidential and which may also be privileged. It is intended for the named addressee only. Unless you are the named addressee, or authorized to receive it on behalf of the addressee, you may not copy or use it, or disclose it to anyone else. If you have received this transmission in error please contact the sender. Thank you for your cooperation.

This e-mail contains Omaha Public Power District's confidential and proprietary information and is for use only by the intended recipient. Unless explicitly stated otherwise, this e-mail is not a contract offer, amendment, nor acceptance. If you are not the intended recipient you are notified that disclosing, copying, distributing or taking any action in reliance on the contents of this information is strictly prohibited.